+49 (0) 6221-3125-0 (Mon-Wed 8 am - 17 pm, Thu-Fri 8 am - 16 pm)

Gear Rack made of plastic - milled

Gear Rack made of plastic - milled
Gear Rack made of plastic - milled
 
   
Application area Model making, laboratory technology, mechanical engineering, high-precision... more

Application area

Model making, laboratory technology, mechanical engineering, high-precision mechanics

Product specification

Form-true gear racks for medium loads, if low weight and/or high chemical resistance is required.

Square gear racks made of plastic.

Module 0.5 / 0.7 / 1.0 / 1.5 / 2.0 (module teeth according to DIN 867), module 2 length 1000 mm is cut for continuous linking.

Alternative cross-section (wide version) with module 1 / 1.5 / 2.0.

Good mechanical strength properties.

Good coefficient of sliding friction.

High stiffness and hardness.

Good temperature resistance.

Not fire-proof and hydrolysis-resistant.

With high hardness and low friction coefficient they can be used in various set-ups, even under water.

Because of the material used, these gear racks are slightly arc-shaped. The gear rack has to be straightened by corresponding fastening material when mounting.

Chemically resistant to dilute alkalis, hydrocarbons, saturated oils, fats and aromatic compounds. Limited resistance to ketones and esters. Not resistant against hot water / suds.

Technical specification

Teeth:

Type: milled teeth, straight tooth system, pressure angle 20°

Quality: 10d25 DIN 3962

Density: 1.425 g/cm3

Elongation at break: 25 - 40 %

Elasticity modulus: 3,300 N/mm2

Max. temperature: +100 °C, for short periods of time +150 °C

No additional information available.
Viewed